Handslide Gate

The Vortex® Handslide Gate™ is designed specifically to handle dry bulk solids in gravity flow conveying. A full flow orifice provides unrestricted conveying of material with no disk or ledges to impede flow or cause material bridging.

• Displacement area as an alternative to packing materials into an end seal
• Live loaded, wear compensating hard polymer pressure plate seals
• Shimming system for in-line maintenance
• Optional locking pin to secure the blade in the open or closed position
• “Scissoring” action reduces seal wear and minimizes material shearing
• Stainless steel liners protect the gate’s seals from material flow
• Mechanically self-cleans its seals on the opening stroke, if actuated to full-open
• No internal cavities to prevent wedging, lodging & spoilage
• Flange options to match up with equipment above and below the gate

Displacement area as an alternative to packing materials into an end seal

Live loaded, wear compensating hard polymer pressure plate seals

Shimming system for in-line maintenance

Optional locking pin to secure the blade in the open or closed position

“Scissoring” action reduces seal wear and minimizes material shearing

Stainless steel liners protect the gate’s seals from material flow

Mechanically self-cleans its seals on the opening stroke, if actuated to full-open

No internal cavities to prevent wedging, lodging & spoilage

Flange options to match up with equipment above and below the gate

Non-abrasive to moderately abrasive powders, pellets and granules. Modifications available for handling corrosive materials and/or for wash-down.

2 – 14 in | 50 mm – 355 mm ID & OD diameters are available. Also available in schedule 10, 20 or 40 pipe sizes.

ANSI & Standard stud bolt pattern Modified pipe flanges available

180° F | 80° C for standard gate, with modifications that allow up to 400° F | 205° C

Nylon, PET, UHMW-PE, 25% glass-filled PTFE, molybdenum disulphide-impregnated nylon

Natural rubber and/or silicone rubber

ATEX Zone 20 (internal), ATEX Zone 21 (external), FDA

Mounting studs are removed and special mounting holes matching an ANSI pattern are provided for bolting through the gate flange. Not all holes are able to be used.

Modifications are made allowing 250 F (121 C) continuous to 300 F (149 C) intermittent service.

Modifications are made allowing 400 F (204 C) continuous to 450 F (232 C) intermittent service.

Gate blade is electropolished. Polyethylene (PET or UHMW) pressure plate seals are used to replace nylon. *Additional modifications available based on application.

Vortex Handslide Orifice Gate vs. Alternatives